Page ID = 001 (1)

page id + code

Details: 

In this case the matching Inland AIS AtoN virtual object shall be shown at the reported positon.

The Inland AIS AtoN symbols shall use the AIS diamond outline as depicted in the table below:

	CODE	CEVNI CODE	ON POS-0	MIS-M	OFF POS-F	VIRT-V	NAME
fixed aids, landmarks	1	4.A + 4.B					Channel near the right bank
	2	5.A + 5.B					Channel near the left bank
	3	4.C + 4.D					Cross-over right bank
	4	5.C + 5D					Cross-over left bank
	5	8.C - 8.C2					Bridge pillar
	6	8.C3 + 8.C4					Overhead cable
floating aids	7	1.A - 1.D					Buoy right-hand side
	8	2.A - 2.D					Buoy left-hand side
	9	3.A - 3.D					Bifurcation
	10	3.E1 + 3.F1					Bifurcation, pass right-hand side
	11	3.E + 3.F					Bifurcation, pass left-hand side
	12	1.F + 1.F1					Danger point or obstacle right-hand side
	13	2.F + 2.F1					Danger point or obstacle left-hand side
	14	-					Berth right-hand side
	15	-					Berth left-hand side
other	16	A.1					No entry * without direction of impact
							No entry * with direction of impact
	17	A.9					Do not create wash * with direction of impact
	18	C.2					Headroom limited
	19	-					Signal float
	20						Reserved for future use
	21						Reserved for future use
reserved	22						Reserved for future use
	23						Reserved for future use
	24						Reserved for future use
	25						Reserved for future use
	26						Reserved for future use
	27						Reserved for future use
	28						Reserved for future use
	29						Reserved for future use
	30						Reserved for future use
	31						Reserved for future use

* For Inland AIS AtoN report the parameter “Name of Aids-to-Navigation” may be used to transmit the direction of impact of the AtoN. This information may be transmitted with or without preceding name value. In this case the content of the parameter contains two percent symbols ‘%%’ directly followed by the direction of impact in full degrees clockwise starting from North e.g. %%270 for direction of impact

The timeout for the display of Inland AIS AtoN shall be 6 times the recommended reporting interval i.e. 18 minutes.

After the timeout period the Inland AIS AtoN symbol shall be immediately removed from the chart and not displayed as lost target. For the AtoNs with an IENC match the charted object will be shown instead.

The following MID are used for the transmission of Inland AtoN information in page 1 of the AtoN status bits in AIS message 21 in Europe:
DRAFT PROPOSAL to be confirmed by the member states